Model Railroading > Atlas Dash8-40B help.

    Hi and a good Friday to all. I bought this loco a while ago knowing the jumper plug was missing. No problem as I had one in my parts box. The problem is
I'm not sure where it goes to run on DCC. Or do I leave it out.Here is a diagram of the area.

                                                                                                                       O  O  O
                                                                                                    ANALOG                    DCC
                                                                                                                       O  O  O

Thanks Steve
                                                                         

Steve , IIRC its a 4 pin plug ?, so for Analog plug in to left 4 pins, and for DCC plug into right 4 pins, been a couple years, or search you tube to double check

Ed Stewart
Jacksonville, FL

calsubd Wrote:
-------------------------------------------------------
> Steve , IIRC its a 4 pin plug ?, so for Analog
> plug in to left 4 pins, and for DCC plug into
> right 4 pins, been a couple years, or search you
> tube to double check

Thank you Ed...